Design a phone holder
A desk stand, wall mount or nightstand dock sized to your phone and case. Pick a style, tune the fit, cable slot and angle. Register to download the STL.
Phone Holder
Stand · Mount · Dock
Style
Prints flat on its base — no supports needed.
Portrait stands the phone tall; landscape lays it wide, e.g. for video.
Ends-only support keeps side buttons untouched.
mm
Support at each end. 10–30 mm.
mm
Mid floor drops this far below the pads. 2–8 mm.
Your phone (including case)
Measure your phone with its case on. The cradle is sized to these plus the fit clearance.
mm
Across the phone.
mm
Top to bottom.
mm
Front to back, including the case.
Where the charging cable enters. The channel routes out the back so the phone sits flush.
Fit & build
mm
Gap on each side of the phone. Min 0.5 mm.
mm
Min 2.5 mm.
mm
Min 3 mm.
Cable slot
Sized for the plug body, not just the wire.
mm
8–20 mm.
mm
5–14 mm.
The dock is always rounded — pick Standard, or Advanced to tune the crest, front-curve and pocket-entry radii.
mm
Ridge that catches the phone bottom. 4–25 mm.
A full-width recess in the back so a camera bump doesn't rock the phone.
mm
Leave blank to use the auto stability depth.
°
From horizontal. 45–80°.
°
How upright the phone stands. 70–80°.
mm
How deep the phone sits (grip). 30–55 mm.
mm
Rounding where the back meets the top. 6–20 mm.
mm
The continuous front curve. 8–30 mm.
mm
Rounded lip so the phone drops in blind. 3–8 mm.
Screw: two countersunk holes through the back. Adhesive: a flat solid back for a 3M strip.
mm
Working…
Rendition